Mulja tv repair portal

Service manuals & datasheets => LCD TV forum => Topic started by: car19 on March 24, 2009,07:09:07

Title: Orion TV32082 dead?
Post by: car19 on March 24, 2009,07:09:07

Hi any body know any thing useful about this set? The set is "Dead" the 5 volts standby and remote voltage is there and when the "ON" is pressed on the set the switching pulse goes into the controller IC but nothing comes out The IC is oscillating as the crystal shows function (Scope test)

Title: Re: Orion TV32082 dead?
Post by: raybla on May 03, 2009,18:26:09

Hi
I am looking at one of these TVs and found that Q406 & Q412 surface mount transistors on the revese side of board are blown to bits - I need a circuit diagram for the transistor info - the power board is CEF286A dont know if this helps you at all - do you have the circuit diagram please regards Ray (UK)

Title: Re: Orion TV32082 dead?
Post by: tv tony on May 06, 2009,06:46:46

no data on the psu but ebay are doing them, under £35.00
tony walker

Title: Re: Orion TV32082 dead?
Post by: raybla on May 07, 2009,16:18:21

Ok Tony thanks for that I will check out Ebay - Regards :thumbup:

Title: Re: Orion TV32082 dead?
Post by: crashzero on November 23, 2009,11:22:16

Hi Ray

have you had any luck with the service diagrams ? I have the same TV and the same problem, its completely dead, but fuse ok, and all components on both side od PSU board CEF286A ok, what else could I check ? I've checked a few places on the PSU and there is 220V ... just dont know what else to check

where should the 5v signal be ?



Thanks
R

Title: Re: Orion TV32082 dead?
Post by: obagama on May 08, 2010,08:12:07

Hi crashzero,

Best thing is to buy a new or used psu on ebay as suggested. Your board should be a vestel 17pw15-8 or buy the new boards 17pw20 v2

cheers