Mulja tv repair portal

Equipment Repairs => CRT TV forum => Topic started by: Turnip on July 29, 2009,08:56:10

Title: Panasonic TX32DTX1 E10D chassis
Post by: Turnip on July 29, 2009,08:56:10

Hi folks,

   Have one of these where set will immediately revert to standby. With patience, and much button pressing, set will come on and perform normally - no amount of bashing or board twisting causes a flicker.

   Only link found was Highlandelectrix where it is suggested to resolder everything - big job. All usual suspect hot areas resoldered but no improvement. Thinking of power supply secondary caps but initial heating makes no difference.

   Any thoughts - Chris.

Title: Re: Panasonic TX32DTX1 E10D chassis
Post by: sparky on July 29, 2009,10:12:32

hi
i had a fault same as above tv many months ago on a philips
28 widescreen it turned out to be the relay, by trail and error when relay split
open the contacts were very tarnished
replaced cured the fault just a thought
sparky

Title: Re: Panasonic TX32DTX1 E10D chassis
Post by: Turnip on July 30, 2009,03:51:54

Hello, and thanks Sparky - good thought - Chris.

Title: Re: Panasonic TX32DTX1 E10D chassis
Post by: DesperateHousewives on August 04, 2009,03:17:21

Thanks, sparky!

Title: Re: Panasonic TX32DTX1 E10D chassis
Post by: veromade on August 14, 2009,05:19:11

Thanks, sparky!
you really helped me