Mulja tv repair portal
Equipment Repairs => LCD TV forum => Topic started by: Turnip on September 09, 2009,13:20:41
-
Hi Folks,
Have a Bush LCD27TV006A where sound consists of just a buzz. Checked through Install menu, where there are just two regional options, neither giving more that a buzz.
Noticed that the EEPROM, an 8 pin in a holder, has been replaced, rather on the skew by previous repairers and might be the problem.
Any thoughts - Chris.
-
hi
whats like thro av input
sparky
-
Hi and thanks Sparky,
Tried all three Scarts, found them identical. Sound present but with fairly loud buzz that goes up and down with volume control. Similar buzz with off-air, but of course, no audio at all - curious.
Thanks again - Chris.
-
do you want current s\w, i have it
-
Hi Tony,
Had a look at the main board, prodded it as it was mikey. Discovered some rather messy component replacements, bottom RH side, (Suspect the Weller man had been there) tidied it up a bit and sound returned on off air analogue, but with the buzz still evident.
So it's not s/w, but a new panel situation, so on to the heap for spares.
Thanks again - Chris.
-
dont be too sure, going into workshop tomorrow, fingers crossed eh?
-
hello chris, managed to get into workshop, ours is a technosonic but i think its what yourre after, pls post piccies of signal pcb, if poss,
tony
-
Hi and thanks Tony,
Working in the wilds of Norfolk, most of my customers have either short pockets or country estates, and all groan at more than a fiver for a Tv repair, so that when I suggested small change from a tenner, he grabbed it and ran.
Sure, city folks have it easy. Thought to attach pic of main board for interest, with mangled area outlined.
Thanks again Tony - Chris.