Mulja tv repair portal

Equipment Repairs => PLASMA TV forum => Topic started by: norman on September 11, 2009,12:16:51

Title: Techwood TWP4210
Post by: norman on September 11, 2009,12:16:51

Hi guys, I have this for repair with seperate media box. The problem is that when you switch on the tv works normally for two or three seconds then reverts to standby, if you switch on again it does the same again. Has anyone came across this before or have any info on this set. Many thanks, Norman

Title: Re: Techwood TWP4210
Post by: waxhead on September 11, 2009,12:58:36

isnt these the sets that have problems with the media box (maybe its to do with that, try powering without it connected).

http://www.avforums.com/forums/plasma-televisions/430214-techwood-twp4210-advice-plus-some-repair-tips.html (http://www.avforums.com/forums/plasma-televisions/430214-techwood-twp4210-advice-plus-some-repair-tips.html)

Title: Re: Techwood TWP4210
Post by: norman on September 11, 2009,13:55:53

Hi Waxhead, thanks for the reply. I was unlucky enough to have two of these for repair recently and found that they don't work without the media box connected (unless someone knows how to get them on). The link you gave me has faults very similar to the symptoms I have so I will check these suggestions. I don't know wether it is the media box or the tv that is at fault. Thanks for the reply, I will post again with any outcome. Thanks, Norman

Title: Re: Techwood TWP4210
Post by: waxhead on September 11, 2009,15:02:20

give the hard reset a go then :dubbio: and go from there :thumbup:

Title: Re: Techwood TWP4210
Post by: norman on September 12, 2009,16:42:55

Hi Waxhead, I have done a hard reset as per link and the set now works normally. Thanks for the link.Cheers Norman :clap:

Title: Re: Techwood TWP4210
Post by: waxhead on September 12, 2009,17:19:12

well that was a cheap and easy repair :mellow: :laugh1: