Mulja tv repair portal

Equipment Repairs => LCD TV forum => Topic started by: papisco on February 01, 2010,12:02:42

Title: sharp LC32 GD9-E
Post by: papisco on February 01, 2010,12:02:42

Help,s Please any suggestions will be highly appreciated, green glows on pictures, but highlights are fine

Title: Re: sharp LC32 GD9-E
Post by: tv john on February 01, 2010,14:26:34

Hi,enter service mode possibly by holding in v- and input buttons on front control panel,plug into mains .Press & hold v- & p- and SIM should appear (sorry can't remember if it was via r/c or front buttons). Scroll to  eeb settings ,clean both and unplug set to exit service mode.Retune tv.
Sorry it's a bit vague,but I lost origional notes.

John.

Title: Re: sharp LC32 GD9-E
Post by: papisco on February 01, 2010,17:07:12

 Hi John, thanks for the reply, but I have tried this procedure with both the r/c and the tv panel but it didn't work, I only have the normal main menu. Please can you look for the notes you may find it.
Thanks

Title: Re: sharp LC32 GD9-E
Post by: pol-uk on February 03, 2010,05:15:25

Turn on Service Menu then go to page 10 and use options at row 1 and second, it should be  EEP Clear. Regards

Title: Re: sharp LC32 GD9-E
Post by: tv john on February 03, 2010,08:35:38

Hi , found it on a european faults site. Switch tv on,unplug at mains,press hold input & vol- on tv whilst plugging into mains.  A 'K' should show ,scroll to EEP clear & press ok.
Press & hold vol- & prog+ together. You might have perform a factory " init " and unplug at mains.

John.

Title: Re: sharp LC32 GD9-E
Post by: papisco on February 03, 2010,17:35:56

Thanks very much John, I have done exactly what you said and it worked.Thw glow on the pictures have gone, and the tv is back to normal, again thanks :thumbup: