Mulja tv repair portal

Equipment Repairs => LCD TV forum => Topic started by: sugz on February 08, 2010,14:16:55

Title: Wharfedale Vestel 17MB15E-3 Firmware Dump
Post by: sugz on February 08, 2010,14:16:55

Hi,

Does anyone have the EEPROM dump for a Vestel 17MB15E-3?  Is it possible to use the 17mb15-7 dump?

Kind regards,

Sugz

Title: Re: Wharfedale Vestel 17MB15E-3 Firmware Dump
Post by: sugz on February 10, 2010,11:42:29

Can anyone help here?  I am looking for the firmware for the board above as i believe the EEPROM has become corrupt. 

Basically, the TV is dead with no standby LED.  This TV has just had a new power supply fitted.  The TV has switched on once or twice after a lot of standby button pressing!  However, i have not managed to get it to power up for a couple of days.

So, if anyone has the firmware, or could point me in any other potential direction, i would be very grateful.

Regards,

Sugz

Title: Re: Wharfedale Vestel 17MB15E-3 Firmware Dump
Post by: JAYROD on February 12, 2010,08:07:01

Hi, have you checked that the output voltages are correct on the voltage regulator ic`s on the MAIN board.I have had IC903 LD1117 2V5 go faulty.
 
 phil.