Mulja tv repair portal

Equipment Repairs => LCD TV forum => Topic started by: Dansford on March 19, 2010,12:16:00

Title: LOGIK LCXW32HD1
Post by: Dansford on March 19, 2010,12:16:00

Hi, I have a LOGIK LCXW32HD1 LCD TV which is dead. Every internal fuse installed is blown. I have replaced the FSD200 on the power supply board but it continues with the same problem.

Any input would be much appreciated!

Thanks in advance

Dansford

Title: Re: LOGIK LCXW32HD1
Post by: Turnip on March 19, 2010,13:18:00

Hi Dansford,

There's usually more than that exploded FSD200 to replace. Most suppliers have a kit with lots'a bits - done some myself. Phoenix kit from Grandata, Wiltsgrove or wherever  - OK - Chris.

Title: Re: LOGIK LCXW32HD1
Post by: tv john on March 21, 2010,04:39:57

Hi guys, check mains smoother as well.

John

Title: Re: LOGIK LCXW32HD1
Post by: michael first on March 21, 2010,05:15:50

Hi,this could help.Good luck.

Title: Re: LOGIK LCXW32HD1
Post by: Dansford on April 15, 2010,08:33:19

Hey, I replaced the smd bridge rectifier on the underside of the board but still same problem. As far as I am aware the FSD200 and DBS106G bridge rectifier are the common source of blowing fuse. I have tested the other components suggested by the repair kit but they all seem functioning.

Any more input would be appreciated !

I'll probably have to buy a repair kit - does anyone know which sites are good for repair kits, I have found a few but they cost more than the TV  :wacko:

Title: Re: LOGIK LCXW32HD1
Post by: sparky on April 15, 2010,10:42:23

what more than £20 tv didn't cost much then, try ohmsupplies fit the
correct one should cure the fault