Mulja tv repair portal

Equipment Repairs => LCD TV forum => Topic started by: markc on May 28, 2010,04:51:35

Title: Daewoo DLT-32C3
Post by: markc on May 28, 2010,04:51:35

We have one of these in that was stuck in standby. Capacitors replaced in PSU, but still the same. EEprom replaced, still the same. S/H main panel obtained and fitted. Set now comes out of standby, but there is nothing on the screen, although the backlight is on.
LDVD panel replaced. Still nothing on screen. :dubbio:
Any suggestions anyone?

Title: Re: Daewoo DLT-32C3
Post by: daz on May 28, 2010,05:23:27

perhaps different screens were used?
try swopping eprom from faulty pcb to the new one.
good luck
daz

Title: Re: Daewoo DLT-32C3
Post by: markc on May 28, 2010,10:06:37

Which eeprom? U31?
There are several on the main panel.

Mark

Title: Re: Daewoo DLT-32C3
Post by: EARLYBIRD on May 28, 2010,10:42:39

Hi.Be careful when changing u31 i believe it is tripled layer print,you might be better cutting the legs on the chip and soldering on to the legs direct.I may be wrong but someone out there might be able to advise you on the correct method.