Mulja tv repair portal

Equipment Repairs => PLASMA TV forum => Topic started by: markc on May 28, 2010,04:57:45

Title: Techwood TWP4210
Post by: markc on May 28, 2010,04:57:45
A couple of questions: How do you do a reset on these sets/box?
I have one which has no picture only a screen full of coured noise in vertical bands/lines.
Can any one help with this?

Buy the way you can get these to run without the box by changing the normal/auto switch on the power supply.
Title: Re: Techwood TWP4210
Post by: daz on May 28, 2010,05:19:54
sounds like the lower y drive pcb is faulty, try removing, you should get half a picture, if so replace along with the y sus pcb, as for running with out the media box, dont think you can on this model, some similar sets had a button which gives a test pattern if box not connected,
good luck
daz
Title: Re: Techwood TWP4210
Post by: waxhead on May 28, 2010,05:53:35
heres how to reset.
http://www.avforums.com/forums/plasma-tvs/430214-techwood-twp4210-advice-plus-some-repair-tips.html (http://www.avforums.com/forums/plasma-tvs/430214-techwood-twp4210-advice-plus-some-repair-tips.html)

but like daz said, dont think its to do with the tuner box, fault would proberly be more to do with a board inside