Mulja tv repair portal

Equipment Repairs => LCD TV forum => Topic started by: t1412 on July 30, 2010,10:00:45

Title: wharfedale 2610af
Post by: t1412 on July 30, 2010,10:00:45

ok chaps just picked 2 of these tv's up they are wharfedales lcd2610af with the same fault after 5 minutes they switch off the owner of the tv's has check the sleep timer in the menu but still the same any reported problems thanks

regards
shaun

Title: Re: wharfedale 2610af
Post by: Turnip on July 30, 2010,13:05:41

Hi Shaun,

Here's a thought - from Quuq old threads -

Wharfedale LCD3210AF LCD
Reverts to standby after 5 minutes and 8 seconds, caused by signal from IDTV PCB shutting down on connector PL500, even when the set was receiving an analogue transmission. Source of the shut down signal was coming from IC100 (STI5518BQC) which is a single chip set top box decoder. Inspecting the PCB indicated that pins 157 to 208 were not soldered from new, and a reflow did the job.
(Indicated in red on LCD2010AF picture)

   Might be useful - Chris.

Title: Re: wharfedale 2610af
Post by: t1412 on July 30, 2010,13:20:18

ok chris thanks just changed capacitors 877/878 15nf will check what you've just said and get back to you

regards
shaun

Title: Re: wharfedale 2610af
Post by: t1412 on July 31, 2010,10:31:10

ok chris that tip you gave me seems to have done the trick m8 thanks again

regards
shaun

Title: Re: wharfedale 2610af
Post by: t1412 on July 31, 2010,13:48:52

right i've got another 1 of these sets with a faint line down the left hand side about 2 inch's wide thanks

regards
shaun

Title: Re: wharfedale 2610af
Post by: Turnip on August 05, 2010,12:29:27

Hi Shaun,

Guess you have screen troubles, but there again, you say faint 'line' LH -2 inches wide. Guess Quuq folks will have ideas, but I don't  - Chris.