Mulja tv repair portal

Equipment Repairs => LCD TV forum => Topic started by: chrissie jones on September 01, 2010,08:43:43

Title: SHARP LC.32D44E-BF
Post by: chrissie jones on September 01, 2010,08:43:43

HI GUYS.GOT THIS SHARP.ON SWITCH ON LIGHT GOES GREEN THEN BACK TO RED. RELAY CLICKS ONCE. :sign0085:

Title: Re: SHARP LC.32D44E-BF
Post by: Contrast John on September 01, 2010,12:49:08

Hi Chrissie
Sounds like a duff ccfl tube. Check out my earlier posts on how to tackle the problem.
Regards
John.

Title: Re: SHARP LC.32D44E-BF
Post by: Turnip on September 01, 2010,13:27:47

Hi, Contrast,

Checked the Sharp LCD 'fault found' area on Quuq, and there 'aint a Sharp - even of any kind.

Guess your'e pulling our lariats - Chris.

Title: Re: SHARP LC.32D44E-BF
Post by: Contrast John on September 01, 2010,14:48:31

Hi Chris
Sorry to cause confusion. Posts are in the lcd forum and not fault database. Here's a link
http://www.tv.quuq.org/forum/index.php?topic=2801.msg7483#msg7483
Have since found that this fault is quite common. Tubes are available from CHS but are expensive!
Regards
John.

Title: Re: SHARP LC.32D44E-BF
Post by: sinclairtv on September 01, 2010,16:44:05

Isnt there a common fault on Sharps where the rivets on the panel must be resoldered. I had a Sharp that cut off and that was the fault.

Title: Re: SHARP LC.32D44E-BF
Post by: Kilroys on September 02, 2010,02:36:28

Lamperror.
Unplug the AC power cord of TV set to force power off.
While holding down the “VOL (–)” and “INPUT” keys on the set at once, plug in the AC power cord to turn on the
set. The letter K appears on the screen. (Factory mode)
Next, hold down the “VOL (—)” and “P ( V )” keys on the set at once.
Look at ERROR STANDBY COURSE.
If it says Lamperror let me know.