Mulja tv repair portal
Service manuals & datasheets => PLASMA TV forum => Topic started by: garethwingrove on October 05, 2010,15:52:31
-
Hi all
Just to say hello to all
Ok
Wondering if any 1 can help me out here i have a 42PF5521D plasma LC4.41E that was struggling to turn on i was getting 5 green leds flashing after 10 min i would get on ,was reading about and came across this forum (can any 1 tell me were it is on board 5 blinks on psu led (vscan failure). Replaced C8104 (22Mf 50v) located on power board near vscan pot. ) i cannot find ????i found 1 cap leaking and changed it (BUT)now im getting 2 rapid 1 slow but does not come on
is this below on this board
LC4.41E
Fault: trips out as picture appears
Solution: 5 blinks on psu led (vscan failure). Replaced C8104 (22Mf 50v) located on power board near vscan pot.
psu board
http://www.tv.quuq.org/forum/index.php?topic=3009.0 first psu picture
-
Hi
check all this components
http://www.tv.quuq.org/index.php?ind=tips&op=entry_view&iden=226
:08:
-
Hi yes changed all still the same
-
This is doing me in lol done lots of joints still no go but heating with hairdryer works going to have to look more rarrrr
-
Hi Gareth,
Not seen the set but have some input - poss from Quuq folks - all the best Chris.
-
good idea,hope you can write more article
________________
Office Home and Student 2010 (http://www.buymsoffice2007.com/office-home-and-student-2010-p-5.html)
Buy MS office 2007 (http://www.buymsoffice2007.com)