Mulja tv repair portal
Equipment Repairs => LCD TV forum => Topic started by: E.R.S. on October 25, 2010,12:02:30
-
Hi, anyone know how to remove child lock on said tv, lock is on from switch on tried all the usual numbers etc
so i think it will have to go into service mode to do it if anyone knows it.
Thanks Steve.
-
Hi Steve,
Not Vestel, notice Main is - PTD9L-10707A001690 / 41 899-CJ0-JL193XBH Rev 01, with a Proview PS from back links - Piccies might be useful.
Not seen one, yet - Chris.
-
hi
have you found service menu code yet? iam trying to get same code for one i have in for r/p
have tried vestel&profilo with no luck as yet if you find it can you post it so i can try
thanx
astracat
ps g/l
-
i use the goodmans ld3255hd on this its < / > buttons it should (if it works 4 ya) put it on screen "child lock on" it maybe the same way but thats whats on this set ;))
-
try this also Child lock removal Switch on at mains switch while holding the volume down on the front controls
Goodmans 2050T CHILD LOCK TO REMOVE HOLD P+ WHILE TURNING ON POWER plamensl 14-09-2004
Goodmans 1403R Child lock removal Switch on at mains switch while holding the volume down on the front controls plamensl 14-09-2004
Goodmans TVC141 Child lock - unlocking press blue/yellow/green/red/standby/standby within 10 secs plamensl 14-09-2004
Goodmans 215N CP365 Chans lock up 13.89Mhz Xtal plamensl 14-09-2004
Goodmans 2043T No OSD or menu Micro lock up, sw off at mains then sw on holding in Vol+/Vol- plamensl 14-09-2004
Goodmans 2045RS/TS No OSD or menu Micro lock up, sw off at mains then sw on holding in Vol+/Vol- plamensl 14-09-2004
Goodmans 215N Lock out all buttons & handset inoperative Replace IC710 ( SN76861NJ12 ) plamensl 14-09-2004
Goodmans TVP14VP TVC1400 No chan change or vol adj Micro lock up - press reset button under front flap plamensl 14-09-2004
Goodmans TX92 chassis Hotel mode (no tuning menu) - to unlock ) turn TV in to standby from remote 2) turn power off from mains on/off switch and wait until led goes off. 3)hold standby button on remote control and power up from on/of switch hold standbye button for about 10 seconds then de/active hotel lock.
lol i'll keep me eye open 4 ya, but try these good luck
-
Hi, thanks to everyone for your help but unfortunately the customer has been and took it back so i can not try your suggestions, i tried to explain that these things take time but what could i do after all the customer is always right. Thanks again Steve.
-
it happens m8 lol good luck, paul