Mulja tv repair portal

Equipment Repairs => LCD TV forum => Topic started by: digitech1962 on February 14, 2011,04:56:12

Title: SHARP LC32DH66E
Post by: digitech1962 on February 14, 2011,04:56:12

This sharp has dead fault led green but wont start up     TV has come on very int thanks .Digi Dave.

Title: Re: SHARP LC32DH66E
Post by: Synyrgy on February 17, 2011,11:42:29

When you say dead fault; do you mean no power indicator light or any signs of power to unit?
Have you checked the power cord, Voltage to unit, Fuse, Bridge rectifier? First things first, Make sure you have 120 VAC to the unit then go from there. Keep me posted? Triumphantcc@yahoo.com

Title: Re: SHARP LC32DH66E
Post by: sparky on February 17, 2011,12:00:54

hi
the supply voltage in uk 240 in usa 120v
check the earthing screws on the inverter
they can cause a few strange faults
dave

Title: Re: SHARP LC32DH66E
Post by: sparkman001 on February 17, 2011,19:13:03

Hi, try this, press 'input' and 'volume -'  on the TV button panel and hold down, then power the set on. If it powers on you should see a 'K' on the screen, press vol- and prog + and you will enter the service mode. scroll through it and reset the backlight error to 0, then power down and restart. Hopefully it will come on as normal. It may be that you have a faulty backlight tube, so try that first.

Title: Re: SHARP LC32DH66E
Post by: Kilroys on February 19, 2011,05:41:19

Could you sometime get the tv working ?
Take looong time before the picture come ?
Take a look at this

Title: Re: SHARP LC32DH66E
Post by: digitech1962 on February 21, 2011,15:46:26

Yes it does sometimes start up but when unplug tv goes back to just green or amber led .

Title: Re: SHARP LC32DH66E
Post by: digitech1962 on February 23, 2011,15:58:59

Thanks for info this points to main board fault thanks.