Mulja tv repair portal
Equipment Repairs => PLASMA TV forum => Topic started by: markc on December 16, 2011,12:26:15
-
This tv will go back to standby about 2 minutes after first switching on.
It can be switched on again, but then only for a few seconds before it goes back to standby.
This cycle can be repeated.
No obvious capacitor faults.
Anyone had this fault before?
Thanks
Mark
-
Update.
The fault turned out to be the fan assy. Full of muck & bearings tight.
It does not run initially, but starts up as the set gets warmer.
As an aside, the set came in without the back on. When I asked where the screws were, i was told
"me made had them, but he's thrown them away." !!!! :stupid: