Mulja tv repair portal
Equipment Repairs => LCD TV forum => Topic started by: billy no mates on December 24, 2011,17:18:06
-
hi
ive been asked by a friend to repair this tv/monitor
powers on then shuts down after about a minute
just had it open and three caps on secondry side of psu bulged so obviously knackered
but gonna get these tomorrow from maplins + a couple of others
what im after is a service/training manual for the above model just in case there are any other faults after caps been changed
hope someone can help
cheers
billy :)
-
Just change caps 80/90% certain to cure. Make sure you use 105 degree ones. Cheers, Doug.
-
cheers doug :)
-
Hi
doug and everyone else
well ive changed caps still no change powers on for a few seconds then backlight goes off and the bloody thing shuts down
model no:- see above
BLUE BIRD 2(17A) 68709M005L
it has a chassis no of : CL-81 060721 C.S
any help greatly appreciated
thanks
billy
-
Hi,a happy N/Y to all,now you should check up the smd MOSFETS on the IP board if everything OK try to override the controller IC's protections.
-
hi michael thanks for the reply,will check tomorrow having a lazy day today lol...a little hungover i dont suppose you know where i could find a service manual for this chassis at all
regards
billy :c017:
-
hi all
mosfets tested ok and i found a service manual but i cant find the protection circuit in the manual i have so im stuck now :41:
any other suggestions
regards billy
-
Hi BNM,
Where's this manual on Quuq ? - Keen Folks will doubtless check your problem and come up with solutions of some sort - Chris
-
hi sorry chris didnt find it on here but i will upload it now
-
Hi Billy,can you tell me what kind of ic is mounted on the inverter board,as the service manual doesn't list it.
-
hi michael
the inverter board and power supply is all in one
there are three surface mount ics on the back of the board
2x 8 pin ics = nikos p210nvc
and 1x 20 pin ic = OZL68GN
regards
billy
-
morning all
has anyone had any ideas of a mod i could try as when first switch on it has a slight pink tint so i suspect a ccfl going bad and making the sensing circuit kick in
regards
billy
-
hi guys
just tried again and noticed when it reverts back to stanbdy i have a slight buzzing noise from speakers and when unpluged from mains i get a popping noise from them also
i dont know if this helps point to anything that may be going or has gone bad on power supply ?
regards
billy
-
hi,unfortunately there are not datasheets for OZL68.sorry
-
hi micheal
thanks for the reply
think im goning to tell him to skip it
regards billy