Mulja tv repair portal

Equipment Repairs => PLASMA TV forum => Topic started by: buggsy on July 23, 2012,15:16:46

Title: TX-P42S10B 5 led flash error
Post by: buggsy on July 23, 2012,15:16:46

TX-P42S10B

got in a this plasma tv in error 5 led flash indicated 5v sos by panasonic service manual indiscates replace the  A  board.

checked on net someone posted changed ysus board fixed fault.

if unplug ysus get 7 flash error then reconnect get the original 5 flash any ideas as donot want to purchase wrong board also ysus is out of stock every where at the moment.

Title: Re: TX-P42S10B 5 led flash error
Post by: jordan on July 23, 2012,15:37:28

Error code 5.........X-SUS board

Title: Re: TX-P42S10B 5 led flash error
Post by: downunder on July 24, 2012,06:23:00

Tread with care, buggsy. SC board can cause SOS code 3, 4, 5 or 7, and is most likely suspect. Ohms check pin 1 of the SC connector (Vs) to ground - power off of course - on the SC board. Good chance it'll read short circuit.