Mulja tv repair portal

Equipment Repairs => LCD TV forum => Topic started by: countrywill on October 23, 2013,09:29:48

Title: Bush S642F
Post by: countrywill on October 23, 2013,09:29:48

Hi guys just wondering if there is anyone on here that can help me with this problem.
I am looking at a Bush S642F Television it comes on ok, but after about 10 – 15 minutes the picture goes off, sound stays on back light is lit, but no picture. If I switch off and back on again the picture will be there but goes off again within minutes.
If I take out the scart plug when picture has gone off and plug scart back in the picture will come back on but only for a minute or 2 any help at all would be appreciated Thanks

I have checked for dry joints and fixed 3 on psu board but it is still the same picture goes off

Title: Re: Bush S642F
Post by: t1412 on October 23, 2013,12:04:46

hi i had the same fault it turn out to be the tcon board, i used freeze spray, spray some on the tcon board around the sm transistor see if the screen goes black,also found it hard to find a replacement, but you might be lucky

regards
shaun   

Title: Re: Bush S642F
Post by: countrywill on October 23, 2013,12:17:06

Hi Shaun thank you for your help but do I spray transistor with freeze while tv is powered on or off? also if it is the tcon board is it possible to replace the transistor. Could the lcd panel also be faulty?

Title: Re: Bush S642F
Post by: t1412 on October 23, 2013,16:39:48

yes i did, as soon i sprayed it, the picture went off i'll show you the picture of the transistor to check ,we manage to replace the tcon and the picture stayed on but it was not a very good picture so might have been fault tcon board i'll send the picture to your email thanks


regards
shaun