Mulja tv repair portal

Equipment Repairs => LCD TV forum => Topic started by: t1412 on August 14, 2014,09:54:31

Title: 17PW25-4
Post by: t1412 on August 14, 2014,09:54:31

hi fella's does anyone have faults list for the 17pw25-4,i've got an alba lcd26advd with flashing standby light thanks for your time

regards
shaun   

Title: Re: 17PW25-4
Post by: Turnip on August 14, 2014,12:23:03

Hi T1412,

Have a faults list,

But in all honesty - Change the board. Repairs might initially seem OK but a board change is the cheapest option unless you want call-backs - Chris.

Title: Re: 17PW25-4
Post by: t1412 on August 14, 2014,13:48:33

hi turnip i'm not really a board changer unless the board is beyond repair , i like the component level challenge if parts are cheap and available , you could send me a list that would be great thanks,

regards
shaun     

Title: Re: 17PW25-4
Post by: kennyc on August 14, 2014,14:35:04

Hi t412. Hope it is the power supply and not the AV/Main board which i have had before .Sometimes hard to tell unless youve changed the board

Title: Re: 17PW25-4
Post by: t1412 on August 14, 2014,14:50:09

hi, kenny yes this is in the back of mind. this one is 17mb62, on the 17pw25 power board there's a row diodes, i;ve floated one end all test good in both directions, i think one is struggling under load cheers

shaun         

Title: Re: 17PW25-4
Post by: Turnip on August 15, 2014,12:48:20

Hi -T1412,

Well if you insist - Attach my 17PW25-4 file - Good luck - Chris.

Title: Re: 17PW25-4
Post by: t1412 on August 15, 2014,15:47:06

thanks turnip if it doesn't work i'll my hands up and say you were right cheers

shaun

 

Title: Re: 17PW25-4
Post by: Turnip on August 16, 2014,12:27:37

Hi Shaun,

Like you, like to mend down to component level, but knowing folks suggested I was wasting my time, as this panel comes back and bites you in the bum when you think you've mended it.

Only mention, as happened to me when I was quite sure of a mend that subsequently cut out every few days for no obvious reasons, and customer was a bit peeved - Good luck though - Chris.