Mulja tv repair portal
Equipment Repairs => LCD TV forum => Topic started by: ANDRASONI on October 06, 2014,09:51:24
-
I have a lcd tv ~ SAMSUNG P2470HD monitor , went without entering anything on any one source of signal.The source to 9V ( 78M09 ) that was damaged .Now TV does not start , the voltage of 9V . is correct .I put back 78M09 source ( the damage I.C. which made only 3.5V ) and not so turn on.Something is happened and I can not figure out why ... I checked carefully if I touched something SMD of nearby, but everything is OK.The voltages 9 , 5, 3.3V is OK.OK does not seem right is that the little 9V power, heats (pin OUT , tablecloth , shows 4,8kO ) ... LED flashes 3 times, then remains lit ( St.By ) .I recently had an identical one with the same fault (source 9V ) , after replacing them worked normal.It would be very useful schematic of the BN94-03503 mainboard , which I found myself, is very brief .Some suggestions?
Equipped with source IP - 58155
mainboard BN94-03503A ~ ECOFIT24 "
Thanks in advance !From Romania, all the best! :051bye:
-
SM Iam send on your email
-
Thank you very much mr. Jordan.This SM , I found myself but is incomplete,missing part 1.92V!!!(I think is not OK) voltage stabilizer which debits.Is it something more detailed, containing all IC-s stabilizer?Thanks again, greetings from Romania, all the best! :051bye: