Mulja tv repair portal
Equipment Repairs => PLASMA TV forum => Topic started by: samisat on February 09, 2015,14:14:46
-
Hi everyone, I got this plasma in which has got screen problem. the picture is too shiny and there are vertical lines as shadow. I did reset factory but no joy.Thanks for time and your help.
Regards sami
-
seen I with similar problems in the end had to replace main board
-
Hi thanks for reply, how about screen as I had one lcd samsung with same problem, replaced t-con board and main board but no joy and at the end screen was faulty.
Thanks
-
Hi Sam,
Tried cleaning the LVDS connector between Logic and Main boards? You could also try test patterns. This would rule out main board.
Unplug TV and remove connector between PSU and Main (at the Main end).
From the legend on the PSU end locate PSU-ON and any RETURN pin and short these two out at the free plug end. A pigtail offcut is ideal.
On the Control, locate the 4 or 6 pin test jig and short out the 2 highest numbered pins - an alligator clip is ideal. Could be pins 6/5 or 4/3.
Plug in the power and observe the test patterns for clarity.
If they are fine, Main board is faulty (as it's been taken out of the equasion).
If they are not, you're not much the wiser. Could be the panel, but not likely.
Ever trying, Bruce
-
Hi Bruce,Thanks for your help, I will try and ll let you know the result.
Kind regard sami