Mulja tv repair portal
Equipment Repairs => Satellite and Freeview forum => Topic started by: harvey on May 16, 2017,07:07:26
-
No output from power supply. All output caps ESR reads ok. Primary section of the PSU board seems ok. The only faulty component found was 33uF 400v capacitor which was dried up and replaced. Still no output at all. Your help appreciated. Regards
-
The switch mode IC UI marked DM0365R can cause problems in these set but are had to source try eBay
-
Thanks for the reply. I will try to find the IC.
-
Have a look here at this pdf data sheet 0365RN.pdf]http://www.promelec.ru/pdf/FSD[M]0365RN.pdf (http://www.promelec.ru/pdf/FSD[M) and the Ebay link https://www.ebay.co.uk/p/dm0365r-fsdm0365rn-switching-power-supply-dip8-ic/702125180?_trksid=p2047675.l2644 (https://www.ebay.co.uk/p/dm0365r-fsdm0365rn-switching-power-supply-dip8-ic/702125180?_trksid=p2047675.l2644)
Dave
-
Hi, Thanks chaps for your help. Problem sorted. It was the IC DM0365R in the primary stage which was faulty. Your advice much appreciated. Regards
-
perfect glad its sorted
:08: :08: