Mulja tv repair portal
Equipment Repairs => LCD TV forum => Topic started by: jose almeida tavares on July 13, 2017,12:47:34
-
Hello, this tv on, displayed sharp logo and hdmi and revert to stby. i need help please.
-
Most likely an error induced by faulty backlight LEDs. If you put it into service mode, it will over-ride backlight protection, most likely you'll get the service menu which indicate cause of shutdown. Check the Lamp Error count, it should be "0". When it reaches "5" it will prevent the set from turning on. Reset it
to "0" and the set should function again, but you'll need to find the cause of the backlight failures. Bruce
-
Hello. O tv fica a apresentar hdmi durante algum tempo e depois desliga. Esse é o problema.
-
Non comprende !
-
Perdon. Escribo en portugues. hable que el tv enciende apresenta el logo de sharp e solamente fica en entradas hdmi e despues se apaga. salud.
-
Hello, i need the firmware. thanks.