Mulja tv repair portal
Equipment Repairs => LCD TV forum => Topic started by: torentino on July 01, 2014,05:05:32
-
Hello,
was jerking around the service menu (https://www.youtube.com/watch?v=htH26DbpOx8) and shit happened. :41:
Enabled searching DVB-T regardless country and MPEG4 and saved settings.
Now white led is blinking at startup, then 2 red blinks. This must be bad speakers contact or something similar.
But I think that are bad settings in eeprom.
Any idea anyone?
UPDATE
Nothing about spekers, the error is 2 38 I2C bus. Was able to communicate with TV, data in atachment. There is also a chassis schematics, cable schematics .
Open .ht file with hyperterminal.
So, any idea?
Anybody has a eeprom dump, just to learn one more thing? :33:
-
hi
try holding menu on tv for more than thirty seconds,failing that update software
regards
astracat
-
No, nothing happens.
Still rebooting. :c023:
-
try update software or enter service with connection on main board
astracat
-
Thank you for your help but how to update sw and where to find it?
For enter service you mean bricking for csm on mainboard?
-
hi update from philips site put on usb stick insert in tv switch while holding menu.main board has special connection short them while turn on tv .send me email address and will try to get you update
regards
astracat
-
I have the same problem what can i do ?
-
hi software update on philips website download and put on usb stick but not in a folder
regards
astracat