Author Topic: Alba LCD W16hdf blue light flashing  (Read 353 times)

0 Members and 1 Guest are viewing this topic.

harvey

  • Jr. Member
  • **
  • Posts: 21
Alba LCD W16hdf blue light flashing
« on: June 09, 2017,08:57:39 »
Hi guys, Good morning. This old LCD was working fine all over the year but when I switched on this morning all I can see only front blue LED is flashing. Looks like its stuck on standby. I ESR all the caps and seems ok. Any suggestion please. Regards

Mulja tv repair portal

Alba LCD W16hdf blue light flashing
« on: June 09, 2017,08:57:39 »

Turnip

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 3217
    • Email
Re: Alba LCD W16hdf blue light flashing
« Reply #1 on: June 09, 2017,09:44:10 »
Hi Harvey,

Flashing Led on a Vestel usually indicates a main board failure of some kind. Could possibly be a short circuit on DC supplies, but usually it's firmware corruption requiring a replacement board as you can't USB update a board on a set that doesn't go - Chris.

jordan

  • Hero Member
  • *****
  • Posts: 804
Re: Alba LCD W16hdf blue light flashing
« Reply #2 on: June 09, 2017,10:29:23 »
Which Power board -------17IPS15-4 ??????
Greeting from Slovenia
Jordan Čebron

Mulja tv repair portal

Re: Alba LCD W16hdf blue light flashing
« Reply #2 on: June 09, 2017,10:29:23 »

harvey

  • Jr. Member
  • **
  • Posts: 21
Re: Alba LCD W16hdf blue light flashing
« Reply #3 on: June 09, 2017,12:24:24 »
Thanks for the reply. Power Brd. Srl No. 17IPS15-3   100908. Regards

t1412

  • Hero Member
  • *****
  • Posts: 702
    • Email
Re: Alba LCD W16hdf blue light flashing
« Reply #4 on: June 09, 2017,12:31:13 »
hi test the large diodes thanks

shaun

vinceroger69

  • Full Member
  • ***
  • Posts: 76
    • Email
Re: Alba LCD W16hdf blue light flashing
« Reply #5 on: June 09, 2017,12:44:55 »
Locate the eeprom/flash ic ic and freeze it with freeze spray does the tv now start ok?
some people say heat these ics but i have had no luck doing that.

Mulja tv repair portal

Re: Alba LCD W16hdf blue light flashing
« Reply #5 on: June 09, 2017,12:44:55 »

Turnip

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 3217
    • Email
Re: Alba LCD W16hdf blue light flashing
« Reply #6 on: June 10, 2017,11:13:24 »
Hi harvey,

Just realised the power board uses an inverter transformer to drive the screen tubes. Tranny goes S/C turns so set won't start. Gather original small transformer is unavailable, but the later one with dual outputs might still be.
If it's the dual output one, check the secondary resistances with an accurate meter, where any difference between them indicates a duff tranny - Chris.

harvey

  • Jr. Member
  • **
  • Posts: 21
Re: Alba LCD W16hdf blue light flashing
« Reply #7 on: June 10, 2017,14:52:32 »
Thanks Turnip for the suggestion. I will have a go at the Tranny if I could find the shorted turns. Regards

 

Powered by EzPortal