Author Topic: Pioneer PDP-LX5090 Kuro if hot & switched off,wont switch on again.  (Read 206 times)

0 Members and 1 Guest are viewing this topic.

bonesy

  • Sr. Member
  • ****
  • Posts: 152
    • Email
Hi guy's,never repaired any Pioneer  Plasma's,this one belongs to a good friend .He tells me that the set switches on & works fine,but if switched off when hot,will not power back on. I've asked him to check for a blue light blink code,which will then give me a clue. I've read on the internet(I know,don't believe a word it say's) but there's more than one post about 8 flashes & a regulator on the AV signals board.Can anyone shed any light on this or is it rubbish?
Many thanks John.

Mulja tv repair portal


downunder

  • Hero Member
  • *****
  • Posts: 828

Hi bonesy,

It' a fact but I don't know if it's in your model, and it usually produces error 8. 3.3V input - 1.8V out. It's your symptoms to a tee, though. Freeze should get it going again and heat will cause it to fail.

IC7951    njm2846dl3-b   on the IC face 846180 - only available from UT Source ASAIK.

Bruce

bonesy

  • Sr. Member
  • ****
  • Posts: 152
    • Email
Hi Bruce,thanks for that,I've found them on e-bay UK supplier,say's fitted to various model Pioneer plasma & DVD units.Just got to wait for set to turn up.

Mulja tv repair portal


downunder

  • Hero Member
  • *****
  • Posts: 828

Ah, good find, bonesy. Good that you can source them locally. Good luck with it because Pioneer boards require that you take out a second mortgage.

Reminds me of the Sony RDR-HXD720_760 that would hang up on "Welcome". Was a similar 1.1V regulator.         Bruce

 

Powered by EzPortal