Author Topic: Phillips 40plf7605h  (Read 391 times)

0 Members and 1 Guest are viewing this topic.

EVILMRB

  • Full Member
  • ***
  • Posts: 53
    • Email
Phillips 40plf7605h
« on: October 27, 2018,11:33:25 »
Hi this tv was just all lines replaced tcon, now have a white bar about 6 inch wide with colours going through. Found this part on the main board shot just near were the cables from the tcon goto, but I don't know what its called here ia a picture if anyone can help. This is what the picture looks like after tcon replacement is it worth buying another mainboard.
« Last Edit: October 28, 2018,07:47:37 by EVILMRB »

Mulja tv repair portal

Phillips 40plf7605h
« on: October 27, 2018,11:33:25 »

astracat

  • Hero Member
  • *****
  • Posts: 255
    • Email
Re: Phillips 40plf7605h
« Reply #1 on: October 27, 2018,13:59:19 »
hi ,its a diode what makes you think its faulty ie. what tests have you tried on this part

EVILMRB

  • Full Member
  • ***
  • Posts: 53
    • Email
Re: Phillips 40plf7605h
« Reply #2 on: October 27, 2018,14:57:22 »
There are 3 in line together and one gives a different reading even when i have taken them out.

Mulja tv repair portal

Re: Phillips 40plf7605h
« Reply #2 on: October 27, 2018,14:57:22 »

EVILMRB

  • Full Member
  • ***
  • Posts: 53
    • Email
Re: Phillips 40plf7605h
« Reply #3 on: October 28, 2018,07:48:47 »
Can anyone get back to me with information on this fault please.

jordan

  • Hero Member
  • *****
  • Posts: 849
Re: Phillips 40plf7605h
« Reply #4 on: October 28, 2018,12:12:03 »
Defect panel
Greeting from Slovenia
Jordan Čebron

EVILMRB

  • Full Member
  • ***
  • Posts: 53
    • Email
Re: Phillips 40plf7605h
« Reply #5 on: October 28, 2018,15:47:37 »
Do you mean the main board Jordan. Thx.

Mulja tv repair portal

Re: Phillips 40plf7605h
« Reply #5 on: October 28, 2018,15:47:37 »

downunder

  • Hero Member
  • *****
  • Posts: 938
Re: Phillips 40plf7605h
« Reply #6 on: October 29, 2018,01:31:07 »

I agree with Jordan. Try removing one flexi between the T-con and display panel, and note the picture you get. Then refit that flexi and remove the other one. If you can get a clear picture or white screen on one half (the right half, I suspect), but not on the other half. then your display panel is kaput.                                          Bruce

EVILMRB

  • Full Member
  • ***
  • Posts: 53
    • Email
Re: Phillips 40plf7605h
« Reply #7 on: October 29, 2018,08:33:43 »
When I remove the flex I get white on one side but still with the lines, and on the other side it still looks like its missing a colour in places. If it is the screen too bad, I only got it out of the local dump anyway.

 

Powered by EzPortal