Author Topic: AKAI AKTV401 , sound ok, no image .  (Read 258 times)

0 Members and 2 Guests are viewing this topic.

amennone

  • Newbie
  • *
  • Posts: 7
    • Email
AKAI AKTV401 , sound ok, no image .
« on: December 03, 2019,17:40:22 »
The problem is the one described in the argument, the sound is ok, but there is no image.
Backlight is on.
On the board (T-CON PANDA 385L RUNTKB070ZZPN - PANDA 385R RUNTKA071ZZPN), integrated on the display the 12 volt voltage is ok.
IC3: HX8915-E is powered (see photo), but there is no voltage on the terminals.
HX8915-E is an equivalent of as15?
The problem is HX8915-E?
Thanks and good job.

Mulja tv repair portal

AKAI AKTV401 , sound ok, no image .
« on: December 03, 2019,17:40:22 »

downunder

  • Hero Member
  • *****
  • Posts: 1059
Re: AKAI AKTV401 , sound ok, no image .
« Reply #1 on: December 04, 2019,01:50:42 »

HX8915 is equivalent to AS15 but it usually results in a poor contrast or fluorescent picture. Never known it to cause no picture.

I could be wrong. Is the IC getting red hot to touch?                                    Bruce

amennone

  • Newbie
  • *
  • Posts: 7
    • Email
Re: AKAI AKTV401 , sound ok, no image .
« Reply #2 on: December 04, 2019,14:15:59 »

HX8915 is equivalent to AS15 but it usually results in a poor contrast or fluorescent picture. Never known it to cause no picture.

I could be wrong. Is the IC getting red hot to touch?                                    Bruce
Hello and thanks for the reply. What should I check?
The chip is cold.

Mulja tv repair portal

Re: AKAI AKTV401 , sound ok, no image .
« Reply #2 on: December 04, 2019,14:15:59 »

amennone

  • Newbie
  • *
  • Posts: 7
    • Email
Re: AKAI AKTV401 , sound ok, no image .
« Reply #3 on: December 04, 2019,15:47:12 »
Hi, when a monitor is connected to the TV Scart output, I don't have
audio and image on the monitor. Should I shift my attention to the motherboard?
is the layout of the CV9203H-A42 main board possible?

downunder

  • Hero Member
  • *****
  • Posts: 1059
Re: AKAI AKTV401 , sound ok, no image .
« Reply #4 on: December 05, 2019,03:04:08 »

Strange that you get no audio via Scart. I have no access to the service manual or board layout for this model but main board is looking like a possibility. Presume you've checked if there's a fuse on the T-con and it is intact.                Bruce

 

Powered by EzPortal
download