LG -RZ-42PX11 y-sus board

[Ron-TV]

Hi All
Back about this y-sus board i have now ordered a replacement board!
The fault i was getting was when tv was first switched on the picture would come on and it was a good clear picture although it did have a few sparklies all over the picture, Then after about 5 miniuts the picture would start to be unstable and go very bright like a negative picture and then the picture would go all together.
I have read up the faults on this set and from what i can see is the ipm has gone faulty on the y-sus board and hopfully a replacement should cure this fault. I am hoping it has not caused any damage to any other componants on any other boards it was mentioned that on the back of the control board there are some grey pads and these have a sticky resin and that can become conductive and cause some problems so i have removed this board and cleaned of this resin, I will keep you all posted on how things go with this set .
In the meantime if anyone has any additional info to add i am all ears.

Kind regards to all Ron-TV