Was looking at the power board today and noticed a fuse was measuring 0 and thankfully changed the fuse and its back to where it was before my stupid mistake - so now back to flash blue light
hi mate wasnt there an eeprom issue with sammys just switching on and off ? sure i heard this or something similar on here .dave
I have followed these instruction ;
1. Short out the eeprom pins 5 & 6 ( the two legs with the resistors ).
2. Turn on the power. - Instead of the usual noticeable relay click, you get a faint click, the backlight stays off, nothing else happens.
3. Wait around 1-2 secs ( anything longer than this NEVER seemed to work ).
4. Remove the short
5. Press info,menu,mute, then power - In that order individually, one at a time.
6. TV should come on with noise picture and the service menu.
7. Navigate to reset to go back to factory defaults and you're away....
I have done 1,2,3 & 4 and when I try 5 the tv just keeps flashing
I had it on its back open and was pulling out different leads and testing it and it worked sometimes but if I try it again with that same lead out then it wont work - strange
