Author Topic: Samsung LE26R86BD (Read 6623 times)

Attilio · « **on:** September 23, 2014,15:17:47 »

A cordial greeting to all,
I have this TV Samsung LE26R86BD with the defect: it tries to turn on but the LED is still flashing, power BN44-00191A is good and after some testing I noticed that the signal "main_power_control" pin 2 cn1101 coming from the main BN41-00813e cyclically from 0v to 3v and as a result tensions on power BN44-00191A up and down.
Someone just happened? and this signal comes directly from the main cpu or some regulator ..
Thank you for any suggestion.
a greeting
Attilio ..

Mulja tv repair portal · « **on:** September 23, 2014,15:17:47 »

sparky · « **Reply #1 on:** September 24, 2014,15:33:41 »

Hi sounds like bga chip on main board replacement board should cure it
try EMOS for board
dave

Attilio · « **Reply #2 on:** September 27, 2014,13:08:35 »

Hello Sparky,

Thanks for the reply
I try and let you know.
thanks
Attilio ..

Mulja tv repair portal · « **Reply #2 on:** September 27, 2014,13:08:35 »

michael first · « **Reply #3 on:** September 28, 2014,17:04:35 »

Hi,if you have bulging caps on the psu replace them then ic1803(24c256 eeprom!) as it could be defective.Ciao!

Attilio · « **Reply #4 on:** September 29, 2014,01:56:31 »

Hello Michael,
thanks for the reply,
the psu is ok and already changed ic 1803 as Sparky says it could be a problem of cpu BN41-00813e. Before I try to change it with a reflow and will let you know.
greetings
Attilio
P.S. I translate with google I hope you understand ....

Attilio · « **Reply #5 on:** October 22, 2014,14:58:00 »

It works !!!!

I did reflow the BGA chip and replaced the 2 SMD capacitors near the chip .
Thanks everyone .

Mulja tv repair portal · « **Reply #5 on:** October 22, 2014,14:58:00 »

Mulja tv repair portal

News: