Humax LU26-TD1 - No go.

[Turnip]

Hi folks,
Had a couple of these in, where the Blue LED might flash or not, but set wouldn't start.

Latest one has always 5v present but nothing else. Was suspicious of Brown'ish rubber glue on the Dongyang PW607D  P/S (bit like a Sammy) so scraped it off B4 it cremated.

Replaced F9222L as they can be a pain but still no go.

Wonder about the 2 main boards, as perhaps no 'turn on' signal, but notice 'Flea' is full of main boards and screens but not a single P/S board in sight.

Any advice - Thanks, Chris.