Good afternoon to the forum.
The image is always in 16: 9 (black space in superior and bottom of the screen). In the right side of the picture it is bent and stretched (E / W).
In the service menu, geometry, does not appear the possibility to change the format function.
If I remove the EPROM (IC500 - 24C08) the TV turns on and stays with image under the same conditions as if it had the EPROM mounted on the chassis.
If I memorize one TV chanel, after switch off the TV, when switch on again, the memory was gone. It seems that the microprocessor dont connected with the EPROM.
With these tips, any colleague could give a tip to repair the TV?
Thank you for your attention.
Topic: Electric Co TV28 (chassis 11AK37) (Read 8158 times)