Well,this is odd.My capacitor came in yesterday,I fitted it in correct location,switched on,hoping for cure,but no!It's a partial cure because my 3.3 volts is now constant,right from power on.If I leave the set to its own devises,you here a relay on power board click once or twice,the back lights flicker a couple of times,then the picture comes on.All this time the green light remains lit.Once picture comes on set then runs for may be five minutes or so,then off to red st-by light.If restarted same thing,green light,slow to come on,flickering back lights,then on.If you look in service mode no errors for backlights at all,plus after a few attempts the set would surely lock you out.Today,I switched her on,picture on after around 15-20 seconds & has run perfectly o.k. so far.I do think
the sets got more than one issue,as I say I now get 3.3 volts all the time.Any Ideas guy's.
