Author Topic: Phillips 40plf7605h (Read 8127 times)

EVILMRB · « **on:** October 27, 2018,11:33:25 »

Hi this tv was just all lines replaced tcon, now have a white bar about 6 inch wide with colours going through. Found this part on the main board shot just near were the cables from the tcon goto, but I don't know what its called here ia a picture if anyone can help. This is what the picture looks like after tcon replacement is it worth buying another mainboard.

Mulja tv repair portal · « **on:** October 27, 2018,11:33:25 »

astracat · « **Reply #1 on:** October 27, 2018,13:59:19 »

hi ,its a diode what makes you think its faulty ie. what tests have you tried on this part

EVILMRB · « **Reply #2 on:** October 27, 2018,14:57:22 »

There are 3 in line together and one gives a different reading even when i have taken them out.

Mulja tv repair portal · « **Reply #2 on:** October 27, 2018,14:57:22 »

EVILMRB · « **Reply #3 on:** October 28, 2018,07:48:47 »

Can anyone get back to me with information on this fault please.

jordan · « **Reply #4 on:** October 28, 2018,12:12:03 »

Defect panel

EVILMRB · « **Reply #5 on:** October 28, 2018,15:47:37 »

Do you mean the main board Jordan. Thx.

Mulja tv repair portal · « **Reply #5 on:** October 28, 2018,15:47:37 »

downunder · « **Reply #6 on:** October 29, 2018,01:31:07 »

I agree with Jordan. Try removing one flexi between the T-con and display panel, and note the picture you get. Then refit that flexi and remove the other one. If you can get a clear picture or white screen on one half (the right half, I suspect), but not on the other half. then your display panel is kaput. Bruce

EVILMRB · « **Reply #7 on:** October 29, 2018,08:33:43 »

When I remove the flex I get white on one side but still with the lines, and on the other side it still looks like its missing a colour in places. If it is the screen too bad, I only got it out of the local dump anyway.

Mulja tv repair portal · « **Reply #7 on:** October 29, 2018,08:33:43 »

Mulja tv repair portal

News: