Author Topic: green on rgb but not s-vid  (Read 4499 times)

0 Members and 1 Guest are viewing this topic.

wayward91

  • Newbie
  • *
  • Posts: 2
    • Email
green on rgb but not s-vid
« on: July 04, 2008,13:53:45 »
hello all,
I have a Sony kv32 fx66u crt tv,(2nd hand) bother the rear rgb scarts display green but the same socket when used with an s-video signal is fine, also the tv tuner displays a normal picture.
The internal boards look fine with no obvious faults on. however the vertical logic/processing board looks newer than the rest of the tv.
I am thinking that is hasnt been re-calibrated correctly/not at all when  (if) it was replaced.
 is there any suggestions on what to do next, i have tried entering the service mode with no success.  :loool:
the setup i use works fine on other tv's so its not a faulty source/cable.

Im not expecting one but if anybody has a service manual for this tv it would be greatly appreciated.

cheers all :-)
« Last Edit: July 04, 2008,13:58:05 by wayward91 »

Mulja tv repair portal

green on rgb but not s-vid
« on: July 04, 2008,13:53:45 »

wayward91

  • Newbie
  • *
  • Posts: 2
    • Email
Re: green on rgb but not s-vid
« Reply #1 on: July 05, 2008,23:38:28 »
can this tv enter service mode?? (without a pc ect)

brainstorm

  • Hero Member
  • *****
  • Posts: 329
    • Email
Re: green on rgb but not s-vid
« Reply #2 on: September 16, 2008,09:43:20 »
Hi,
What are you feeding into the set?
i.e make and model
I have had this symptom before when cheap DVD players are being used,
if this is the case then try feeding in a decent quality RGB signal from a good quality DVD player ie sony. Also you could try altering the output from the DVD player you are using from RGB to Composite Video if it has that facility

Mulja tv repair portal

Re: green on rgb but not s-vid
« Reply #2 on: September 16, 2008,09:43:20 »

 

download
download
download