Author Topic: MAXIM 1154 (Read 5062 times)

daz · « **on:** March 14, 2009,08:52:37 »

PSU WAS BLOWN.I HAVE REPAIRED THE PSU USEING THE REPAIR KIT AND NOW THE 5V STANDBY CIRCUIT IS RUNNING, HOWEVER ALL THE SET DOES IS THE GREEN LED FLASHES ONCE THEN THE RED LED FLASHES 6 TIMES, THEN IT REPEATS. DOES ANYONE HAVE ANY IDEAS?

Mulja tv repair portal · « **on:** March 14, 2009,08:52:37 »

tv tony · « **Reply #1 on:** March 14, 2009,09:28:23 »

please post psu piccie
tony walker

Turnip · « **Reply #2 on:** March 14, 2009,10:05:51 »

Hello folks,

If this is the PT 1000 chassis,very interested about this one, have the Bush version where the 5v chopper (FSD200) blew it's top, caps drooled down the board killing the 24v supply. Have now got 5v S/by and 24v supply going, but just a pulsing input into IC37 (12v Opto) but no output from IC37 and all normal start-up supplies and no shorts around IC30 (ICE1QS01) or the secondary side. Supply will not fire up.

Thanks Chris Steele.

Mulja tv repair portal · « **Reply #2 on:** March 14, 2009,10:05:51 »

daz · « **Reply #3 on:** March 14, 2009,10:42:09 »

GOT IT GOING, TURNED OUT TO BE A VERY DRY JOINTED S300 CONNECTOR

pol-uk · « **Reply #4 on:** September 22, 2009,17:32:17 »

I've got the same PSU after repair, but backlight is flickering. When I switch it ON it make from 24V abou 17 to 19V. Any ideas ?? REGARDS

Mulja tv repair portal · « **Reply #4 on:** September 22, 2009,17:32:17 »

Mulja tv repair portal

News: