Author Topic: Bush LCD27TV006HD - Sound. (Read 5592 times)

Turnip · « **on:** September 09, 2009,13:20:41 »

Hi Folks,

   Have a Bush LCD27TV006A where sound consists of just a buzz. Checked through Install menu, where there are just two regional options, neither giving more that a buzz.

  Noticed that the EEPROM, an 8 pin in a holder, has been replaced, rather on the skew by previous repairers and might be the problem.

   Any thoughts - Chris.

Mulja tv repair portal · « **on:** September 09, 2009,13:20:41 »

sparky · « **Reply #1 on:** September 09, 2009,13:53:15 »

hi
whats like thro av input
sparky

Turnip · « **Reply #2 on:** September 10, 2009,08:00:13 »

Hi and thanks Sparky,

Tried all three Scarts, found them identical. Sound present but with fairly loud buzz that goes up and down with volume control. Similar buzz with off-air, but of course, no audio at all - curious.

Thanks again - Chris.

Mulja tv repair portal · « **Reply #2 on:** September 10, 2009,08:00:13 »

tv tony · « **Reply #3 on:** September 10, 2009,10:33:04 »

do you want current s\w, i have it

Turnip · « **Reply #4 on:** September 10, 2009,10:58:41 »

Hi Tony,

Had a look at the main board, prodded it as it was mikey. Discovered some rather messy component replacements, bottom RH side, (Suspect the Weller man had been there) tidied it up a bit and sound returned on off air analogue, but with the buzz still evident.

So it's not s/w, but a new panel situation, so on to the heap for spares.

Thanks again - Chris.

tv tony · « **Reply #5 on:** September 10, 2009,11:54:15 »

dont be too sure, going into workshop tomorrow, fingers crossed eh?

Mulja tv repair portal · « **Reply #5 on:** September 10, 2009,11:54:15 »

tv tony · « **Reply #6 on:** September 11, 2009,07:30:54 »

hello chris, managed to get into workshop, ours is a technosonic but i think its what yourre after, pls post piccies of signal pcb, if poss,
tony

Turnip · « **Reply #7 on:** September 11, 2009,10:57:20 »

Hi and thanks Tony,

Working in the wilds of Norfolk, most of my customers have either short pockets or country estates, and all groan at more than a fiver for a Tv repair, so that when I suggested small change from a tenner, he grabbed it and ran.

Sure, city folks have it easy. Thought to attach pic of main board for interest, with mangled area outlined.

Thanks again Tony - Chris.

Mulja tv repair portal · « **Reply #7 on:** September 11, 2009,10:57:20 »

Mulja tv repair portal

News: