Author Topic: Hitachi 42PMA400A Plasma (Read 9426 times)

Typhoontimmy · « **on:** October 04, 2009,05:55:37 »

Hi there
I have a Hitachi 42PMA400A Plasma and it has a power up problem. when you turn it on the realy clicks and the light on the front goes from red to green and it displays the picture for a split second and it goes away and about 5 seconds later the light goes back to red and the relay clicks.

People have told me "just replce two Caps in the YSUS board and this will fix the problem but i have replaced a total of 12 Caps in the board already and it's still doing the same thing.

plz help

Mulja tv repair portal · « **on:** October 04, 2009,05:55:37 »

PMZ · « **Reply #1 on:** October 23, 2009,08:34:13 »

Hi,
I'm not too familiar with the 400A but an earlier model 350???

(memory not too good) had a similar fault and it turned out to be the 5v standby circuit at fault. Could yours be the same?
Regards,
PMZ.

Typhoontimmy · « **Reply #2 on:** October 26, 2009,02:02:50 »

Hey thanks for the reply

with the 5v standby circuit is that on the main power supply

Mulja tv repair portal · « **Reply #2 on:** October 26, 2009,02:02:50 »

brian · « **Reply #3 on:** October 26, 2009,12:00:09 »

Hello,
Had a different model,type 42PMA500 and not sure if same/similar p.s.
as yours, but check diode D114 for short, and dry joints on IC202. As I say might be worth a look!
Cheers
Bri.

Typhoontimmy · « **Reply #4 on:** November 08, 2009,02:26:32 »

Hey Brian thanks for the reply

With the diode D114 isit on the ysus board.
cheers

Typhoontimmy · « **Reply #5 on:** November 08, 2009,02:50:01 »

Also i have and lg 42pxp... and the screen works fine but once it heats up it flickers on and off like there is a dry joint somewhere. Is this correct or do i have to replace a board to fix the problem. Cheers

Mulja tv repair portal · « **Reply #5 on:** November 08, 2009,02:50:01 »

brian · « **Reply #6 on:** November 09, 2009,10:15:20 »

Hi,
From memory!! the diode D114 is a ERA91-02 type and was on the power supply
It had gone short.
Cheers
Bri.

astracat · « **Reply #7 on:** November 12, 2009,17:24:29 »

hi typhoontimmy
had a similar problem with an hitachi power up ok for few seconds, found relay supply resister had gone high maybe worth a check for your problem
g/luck
astracat

Mulja tv repair portal · « **Reply #7 on:** November 12, 2009,17:24:29 »

Mulja tv repair portal

News: