VIEWSONIC N3260W OR HANNSSPREE jt01-32e2-000g or tecotl3281rt.

[maff99]

Hi Guy's got one of the above with a duff p.s.u. most of the secondary caps u/s.replaced the caps & fitted a p.s.u. repair kit41 from c.h.s. ltd.which usually sorts them out.but this time I've got an extra resistor gone up which I can't read the value.It's marked r65 surface mount.Has anybody got a service manual or any idea of it's value.p.c.b. type fsp228-3f01.
many thanks Maff.     

[Contrast John]

Hi Maff
Spent some time rebuilding a similar psu in a Swisstec LCD tv. Have a look in the Faults Database  section and select the category `other makes`, then open the `jump to category` bit at the bottom of the screen to find the Swisstec entries. Sounds quite similar to your problems although the board number is slightly different. R65 was a sm 5.1 ohm feed resistor for a sm regulator transistor that was s/c. Full details in the fault section. Hope it helps.
Regards
John.

[maff99]

Thanks for that john.Set ran for about 20 mins then died again.This time r28 & 29 burnt up seem to feedi.c. 2 which I replaced in the kit. Back to the drawing board.  :wallbash:

[brian]

Hi Maff.
Might be worth checking the Fets and caps on the inverter.
Regards
Bri.
P.s. saw this on another forum.

[maff99]

Thanks Brian,I'll check that out once I get out of this straight jacket they have put me in  :wallbash: Don't suppose anyones got a circuit for this p.s.u.type FSP228-3F01.TECO.Hate to be beaten .Going to sit back in the corner now & rock backwards & forwards  :wacko: thanks maff