Author Topic: BUSH IDLCD26TV07HD (Read 8385 times)

adm2007 · « **on:** February 12, 2010,08:32:05 »

HI GOT THIS BUSH IDLCD26TV07HD IN FOR REPAIR. WHEN SWITCHED OUT OF STBY YOU HAVE TO RETUNE THE DIGITAL CHANNELS ANALOGUE OK.ALSO WHEN SWITCHED OUT OF STBY THE STBY LIGHT FLASHES.IF SWITCHED OFF AT WALL SOCKET IT COMES ON OK.ANY IDEAS USED TO FAX BUSH BUT THERE NUMBERS CHANGED.THANKS CARL

Mulja tv repair portal · « **on:** February 12, 2010,08:32:05 »

SUPER8 · « **Reply #1 on:** February 12, 2010,09:01:59 »

Hi sorry unable to help with your fault, but today I have one in for repair and I was hoping you can tell me the value of R954 in the PSU. Thanks in anticipation SUPER8

adm2007 · « **Reply #2 on:** February 12, 2010,09:58:47 »

sorry mate customer had set back till find whats wrong

Mulja tv repair portal · « **Reply #2 on:** February 12, 2010,09:58:47 »

sparky · « **Reply #3 on:** February 12, 2010,17:06:37 »

hi
super8 on chs site you can blow up psu that they supply
it shows your resitor
sparky

SUPER8 · « **Reply #4 on:** February 13, 2010,06:32:11 »

HI Sparky tried that but its to blurred too blurred to make it out but thanks.

Turnip · « **Reply #5 on:** February 13, 2010,08:36:01 »

Hi folks,

Just a thought, is the P/S a FSP204 - think I have one kicking about and could check value - Chris

Mulja tv repair portal · « **Reply #5 on:** February 13, 2010,08:36:01 »

sparky · « **Reply #6 on:** February 13, 2010,10:13:26 »

beko psu Z1J194-11 looks like 15ohms

Contrast John · « **Reply #7 on:** February 13, 2010,14:40:02 »

Hi all
Have uploaded a rather blurry schematic of a Beko Z1J194 power board. It`s located in the downloads section filed under Beko lcd. Not easy to read component values but it gives an idea of how the psu works. It`s worth noting that the two power supplies on the board are very similar so you might get an idea of your resistor value by following the print and comparing component values in each circuit. Hope it`s of some help.
Regards
John.

tv john · « **Reply #8 on:** February 23, 2010,18:32:35 »

Back to adm2007's post.You might have to deactivate "plug&play" function via s.mode.Try main menu,
highlight pic icon and punch in 9301. Sorry,don't have any more info.
Best of luck, John.

Mulja tv repair portal · « **Reply #8 on:** February 23, 2010,18:32:35 »

Mulja tv repair portal

News: