Author Topic: Daewoo DLT-32C3 (Read 4369 times)

markc · « **on:** May 28, 2010,04:51:35 »

We have one of these in that was stuck in standby. Capacitors replaced in PSU, but still the same. EEprom replaced, still the same. S/H main panel obtained and fitted. Set now comes out of standby, but there is nothing on the screen, although the backlight is on.
LDVD panel replaced. Still nothing on screen.

Any suggestions anyone?

Mulja tv repair portal · « **on:** May 28, 2010,04:51:35 »

daz · « **Reply #1 on:** May 28, 2010,05:23:27 »

perhaps different screens were used?
try swopping eprom from faulty pcb to the new one.
good luck
daz

markc · « **Reply #2 on:** May 28, 2010,10:06:37 »

Which eeprom? U31?
There are several on the main panel.

Mark

Mulja tv repair portal · « **Reply #2 on:** May 28, 2010,10:06:37 »

EARLYBIRD · « **Reply #3 on:** May 28, 2010,10:42:39 »

Hi.Be careful when changing u31 i believe it is tripled layer print,you might be better cutting the legs on the chip and soldering on to the legs direct.I may be wrong but someone out there might be able to advise you on the correct method.

Mulja tv repair portal · « **Reply #3 on:** May 28, 2010,10:42:39 »

Mulja tv repair portal

News: