Author Topic: Seleco SVD500 Plus (Read 6271 times)

frontop · « **on:** May 28, 2010,07:49:46 »

Hi everybody,

Can somebody help with Seleco SVD500 Plus microprocessor board dump?

Mulja tv repair portal · « **on:** May 28, 2010,07:49:46 »

Turnip · « **Reply #1 on:** May 28, 2010,12:19:35 »

Hi Fromtop,

Don't have it listed - what is it ? - Chris.

frontop · « **Reply #2 on:** May 28, 2010,14:10:06 »

Hi Turnip,
my English is not the best ,but I will try to explain.I'm talking about the microprocesor board eprom software.I own this Seleco SVD500Plus ,and it's happened to don't start the tubes.The diagnostic said the problem is with this eprom sw. the eprom was overwrited with the sw downloaded from the Seleco400+.Now the PJ is usable ,but is not the same as was before.So ,this is why I'M here. Levente

Mulja tv repair portal · « **Reply #2 on:** May 28, 2010,14:10:06 »

Turnip · « **Reply #3 on:** May 29, 2010,13:06:00 »

Hi Levente,

Guess it a tube projection set - have no info but quuq folks may well help, hopefully - Chris.

Mulja tv repair portal · « **Reply #3 on:** May 29, 2010,13:06:00 »

Mulja tv repair portal

News: