Goodmans LD3266D lcd TV

[yellowpinky]

Hi Group,
Sound with no picture.
The back lights come on for a few seconds and then go out.
I have checked the back lights and replaced the inverter
(4H.V0708.411/B), but still have the same fault.I have 23v on all 3 inverter fuses.
Has anyone any sugestions.
Many thanks Ian Harrison (Sound and Vision)
ianharrison40@hotmail.co.uk

[sparky]

hi
it prob screen faulty

[Contrast John]

Hi yp
Might be a duff ccfl tube causing the driver IC to go into protection when it doesnt strike up.
Regards
John.

[Turnip]

Hi,

Is this Vestel ? suspect it is - Chris

[yellowpinky]

Hi All,
I have tryed the ccfl tubes by substution but no change.
It is not a Vestel, I have taken some pics.
Best regards Ian.

[WILLYAM1]

hi .
i hade the same tv in another brand INFINITY 32'' same problem as you discribe above.after changing inverter+p.s no luck  i notice that 24v in inverter is ok even screen is off  and pin inverer on is changing to off.
replace main board tv is ok.
willyam1

[yellowpinky]

Hi Willyam1,
Where did you get the board?
Regards Ian.

[udaydabke]

Put the tv on whern you get sound put a bright light behind panel where backlight enters and see if you could see the faint picture, if yes then lcd pannel is not faulty.backlight itself functioning or not? if it doesn't after replacing inverter then look for memory ic. this problem is mostely bacause of memory ic

Hi Group,
Sound with no picture.
The back lights come on for a few seconds and then go out.
I have checked the back lights and replaced the inverter
(4H.V0708.411/B), but still have the same fault.I have 23v on all 3 inverter fuses.
Has anyone any sugestions.
Many thanks Ian Harrison (Sound and Vision)
ianharrison40@hotmail.co.uk

[Contrast John]

Hi Guys
As the 24volt line to the inverter board is probably switched off in standby, it might be possible to arrange a 'modification' to put 3volts or so onto the 'enable' line of the inverter board and keep it enabled. Only drawback is figuring out which connection it is on the inverter plug n socket so you can break the feed and apply the 3volts. Have found that schematics for a lot of ccfl drive chips are available on the internet so it might be worth investigation.
Regards
John. 

[WILLYAM1]

hi.
got the main board from a broken panel that costumer sold me..
 
i got lucky this time.
willyam1

[yellowpinky]

Hi Group,
I have tried a strong light behind panel and still have no display.
The enable line to the inverter measures 4v when the ccfl strike and remains there after they go out.
I think it must have a faulty screen, but I can not be sure.
Thanks for all the help
Regards Ian