Author Topic: Toshiba 36ZP38B (Read 7369 times)

markc · « **on:** June 25, 2010,08:27:46 »

Hi,
I have one of these that is stuck in standby. I have replaced the module MDFS03, but the fault remains.
The Xtal on the micro is running but there is nothing on the external data/clocks. Not sure if there should be in standby?
Does anyone have any suggestions as to where to go next please.
Thanks
Mark

Mulja tv repair portal · « **on:** June 25, 2010,08:27:46 »

daz · « **Reply #1 on:** June 25, 2010,08:44:18 »

hi mark
try removing the text module, this has a painter chip on it and causes all sorts of problems, if no joy check all cp there are quite a few on this set
good luck
daz

mulja · « **Reply #2 on:** June 25, 2010,11:08:45 »

I had this problem before

was short circuit in scan coil

Mulja tv repair portal · « **Reply #2 on:** June 25, 2010,11:08:45 »

markc · « **Reply #3 on:** June 26, 2010,04:35:32 »

Thanks for the replies. I had tried removing the text module, but no joy.
I will recheck the CP's. If the micro power on pin is taken low the set will power up, so I don't think it's the scan coils, but its a thought.
Mark

markc · « **Reply #4 on:** July 07, 2010,09:54:28 »

An update for those that are interested:
The fault was caused by the remote sensor, although it was sending data to the CPU, the data must have been corrupt or of the wrong level?

Mark

daz · « **Reply #5 on:** July 08, 2010,04:43:20 »

thanks for the update mark
was wondering about this one,strange fault for a tosh.
daz

Mulja tv repair portal · « **Reply #5 on:** July 08, 2010,04:43:20 »

Mulja tv repair portal

News: