Author Topic: LG 32LC46 stuck in stand by (Read 9257 times)

Vlad · « **on:** March 13, 2011,12:30:46 »

Hello

When I try to switch the TV on front led goes from stand by (red) to green it flash 3 times and stays on for 5 seconds, after that the TV is going back to stand by.
I replace all capacitors on the PSU but it is still the some.

Mulja tv repair portal · « **on:** March 13, 2011,12:30:46 »

Vlad · « **Reply #1 on:** March 18, 2011,04:01:07 »

I replace all capacitors, Check all tranzistors and Diodes still the some

Turnip · « **Reply #2 on:** March 18, 2011,12:51:09 »

Hi Vlad,

Don't have it listed how about a pic and/or some panel numbers ? Chris

Mulja tv repair portal · « **Reply #2 on:** March 18, 2011,12:51:09 »

Vlad · « **Reply #3 on:** March 18, 2011,15:58:25 »

I make 4 puctures

kennyc · « **Reply #4 on:** March 19, 2011,08:22:13 »

hi vlad . i have got 2 lg tvs for repair .th first one just has the green light flashing and the second has back light on and grey screen and menu shows on screenwhen pushed . one is a 32inch and the other is a 37 inch . swopped over the main av board with the tuner on it and did vica versa and the faults have switched . i can only assume that both the av boards are faulty even though the faults are not the same

davenjax · « **Reply #5 on:** March 19, 2011,09:38:59 »

hi if you look at the main pcb number .put it into the forum i think there are some mods listed for these boards.dave

Mulja tv repair portal · « **Reply #5 on:** March 19, 2011,09:38:59 »

Vlad · « **Reply #6 on:** March 19, 2011,14:22:34 »

Chasis: LD/PD73/75A
EAX35231403 (0)
06.11.28

Vlad · « **Reply #7 on:** March 20, 2011,02:53:23 »

I found the problem
Was lifting the tv today morning and from left side feel small burning smell. Problem is bad connection between tubes

Thanks for all help

davenjax · « **Reply #8 on:** March 20, 2011,05:37:21 »

great job and thanks for posting the cure .good result .dave

Nick85 · « **Reply #9 on:** December 31, 2011,15:14:07 »

Quote from: Vlad on March 20, 2011,02:53:23

I found the problem
Was lifting the tv today morning and from left side feel small burning smell. Problem is bad connection between tubes
Thanks for all help

Hi there how did you manage to sort the problem out exactly as I'm having the same problem, I've changed capacitors that had gone now seems like light in the TV not working properly but not sure if that anything to do with it but all its doing is the screen flashing on and off few times then goes back into standby. Please help. Thank you.

Mulja tv repair portal · « **Reply #9 on:** December 31, 2011,15:14:07 »

Mulja tv repair portal

News: