Author Topic: BEKO NR35228PD (Read 8694 times)

t1412 · « **on:** June 13, 2011,11:08:07 »

ok guys got this old beko it's a nr35228pd repairiing it for an old lady up the road. at switch on dead took the back off found main fuse blown put another1 same again tested output transistor ok . any other ideas got a feeling it could be the lopty cheers

shaun

Mulja tv repair portal · « **on:** June 13, 2011,11:08:07 »

daz · « **Reply #1 on:** June 14, 2011,04:28:05 »

hi
check psu for shorts, if none change positor
good luck
daz

t1412 · « **Reply #2 on:** June 14, 2011,12:37:05 »

cheers daz you would happen to have a schematic knocking about cheers

shaun

Mulja tv repair portal · « **Reply #2 on:** June 14, 2011,12:37:05 »

daz · « **Reply #3 on:** June 15, 2011,08:43:17 »

sorry shaun dont have one for this set, but some other quuqer might

Turnip · « **Reply #4 on:** June 17, 2011,12:48:46 »

Hi T1412,

Had lots of tubed Beko in where spurious mains fuse blowing was a decent earner - got rid of most my positors apart from those odd Philips ones that were not series in operation - typical Philips - they just have to do it differently.

Have a schematic - attached - all the best - Chris

t1412 · « **Reply #5 on:** June 17, 2011,20:34:52 »

i.ve change the posistor it stop blowing fuses but still dead. chris really gratefull for the schematic

shaun

Mulja tv repair portal · « **Reply #5 on:** June 17, 2011,20:34:52 »

Mulja tv repair portal

News: