Forum > LCD TV forum

Logik LCXW32HD1-Standby Transformer Problems

(1/8) > >>

scooby-doo:
I have just screwed up, bought a repair kit for the Logik LXW32HD1 "Blowing Fuses" fitted all ok, it stopped blowing fuses but I am not getting any voltages.
In the description where I bought the kit, it did mention to test the Standby transformer(16es-x03), I decide to do this now and found it's fluffed.

What can I do? is there an alternative. please dont say rewind it, I will fluff it up.

Thanks for any help

sparky:
hi
is it t20? or t21? try ohmsupplies they stock them i believe it is the
5volt supply
dave

Ohm Supplies:
Dave is right, it is a 5v stand by transformer however its not available as a separate item.

The damage to is was caused by U2 blowing, it doesn't short internally but blows the wire from one of the legs to the windings. Its simple if a bit tricky to repair but I can instruct you how,
Where did you buy the kit from?
Regards
Andy

scooby-doo:
Cheers Andy/Dave

It is the standby 5 volt transformer T4, I can see which leg is blown as the yellow tape is burnt and so is the board by one of the pins.

Sorry Andy went to your competitor CHS   :c023:
Should of bought the bits individually as it was only three parts of the kit that were blown, U2 DB1 and T4...which is not included.

I am going to have a look now to see if I can have a go at fixing  the transformer if I get stuck I will give you a shout.

Thanks anyway

scooby-doo:
Bloody hell that is a little fiddly, getting a reading from the pins now so just going to fit and see, will let you know how it goes.

Thanks again,

Navigation

[0] Message Index

[#] Next page