Author Topic: What can i do with flashing tv (power board: 04TA069I) (Read 5809 times)

vmartin · « **on:** August 25, 2011,18:34:24 »

Hello,
I have TV Schnieder LDT 3205 with power board 04TA069I. After a few minutes TV screen and LED diode begins to flash. Where can be mistake?
I can measure 115V on a radiator in the center of board and 100V on a frame.
I have got no scheme. What could be wrong?
Thank you for all ideas.

Mulja tv repair portal · « **on:** August 25, 2011,18:34:24 »

dougc · « **Reply #1 on:** August 25, 2011,18:50:16 »

Hi, Look for bulging capacitors on the secondary side.

vmartin · « **Reply #2 on:** August 25, 2011,19:04:18 »

Thank you very much. Do you think that transistors are good?

Mulja tv repair portal · « **Reply #2 on:** August 25, 2011,19:04:18 »

dougc · « **Reply #3 on:** August 25, 2011,19:16:30 »

with regard to that particular fault I haven't had any transistor problems, Check all the caps at the top right hand side of board, Regards, Doug

dougc · « **Reply #4 on:** August 25, 2011,19:25:52 »

Just a thought, If the screen lights up initially then the set shuts down resolder connections on supply sockets to inverter - it could also be a faulty inverter.

vmartin · « **Reply #5 on:** August 26, 2011,05:48:00 »

Thank you for ideas. Do you think invertor on the right side? (27mH)
http://tvpartsfixit.co.uk/Images/Parts/286.jpg

Mulja tv repair portal · « **Reply #5 on:** August 26, 2011,05:48:00 »

vmartin · « **Reply #6 on:** August 26, 2011,06:59:20 »

I disconnected all cables and the voltage (100V) is still on the board. Is it ATX supply?
Thank you :-)

Mulja tv repair portal · « **Reply #6 on:** August 26, 2011,06:59:20 »

Mulja tv repair portal

News: