Forum > LCD TV forum

Bush A642F - main board problem ?

<< < (2/3) > >>

Turnip:
Hi F-I-N, nice one, will give it a go - reply tomorrow,

Forgot to mention that on pressing 'Menu' on the set - after board change, cursor buttons on RCU worked, enabling a full reset and re-tune - even RCU S/by button functioned.

Out of 'Menu' no RCU buttons work - some strange Bush - Thanks again - Chris

Turnip:
Hi FIN and many thanks,

Was doubtful but it did the biz -  :08: - My first Quuq emoticon, ever  - Thanks again - Chris

old tvman:
Anyone know how to enter the service mode for this model, I have a similar problem to the above posts,Will go into standby with the remote control but wont come out of sby with remote or keypad (have to switch of at mains and reconnect whilst holding keypad sby button) set comes on and all remote functions work but no operations on  keypad.
thanks davy

jordan:
This appliance use chassis 715G34621/China
All instruction in page 53
!!! Press and hold MENU button on front panel for about 5 sec,release the MENU button and press the MENU button on RC.Apply above operations to toggle between remote ON/OFF

old tvman:
Cheers jordan ,much oblidged will try this later.
thanks davy

Navigation

[0] Message Index

[#] Next page

[*] Previous page